Home / Forums / Vehicle maintenance, suggestions and ideas / wiper wiring
wiper wiring
Hi help required.1972 crossover.Wipers do not self park.I have three spare motors,have tried to work out wiring with din numbers but there aren't any on the wiper body.Have worked out by trial and error that the green wire goes to 53a on the switch, black to 53,black/yellow to 53b,and the black/white which according to Haynes should go to 31b also goes to 53,as this seems to be live when switched on.According to Haynes manual there should be points to adjust but can't find any.the only places of adjustment is the plastic screw which I think is for end float and a screw with lock nut on the cover plate of the drive,how are these properly adjusted.30 on the switch is live and 31 is earth.Sorry for long explanation hope it is clear.Hope some with knowledge can help Thanks Mike.
Sorry, I can't help you at all with vehicle elctrics, they're a bleedin nightmare. Most mechanical yes...Electrics no. sorry.
Hi help still needed please.In my original post on reading it thoroughly it sounds as though I was questionong the validity of information in the Haynes manual,this I would never do finding Haynes a most valuable source of information on hundreds of cases.I was trying to state probably very poorly that there was something wrong with either the motor,switch or my knowledge of wiring which is more than likely the case.Could anyone please advise me using the colour code as to where on the switch the wires go.Thanking in anticipation,Mike.